YZPR High pressure reactor
 
Features
CE certified (No 8600406)
Standard: EN 61010-1:2010; EN 61326-1:2013
Snap ring design
Easy to remove the reactor from the heating furnace
Support bottom tube sampling
Support catalyst filtration
LCD true colour touch interface
Magnetic coupling (available on selected models)
Cast copper heating for fast heat transfer
Temperature control program
Digital pressure readout
Support safe interlock
Over-temperature and overpressure alarm
Fully customisable for specific requirements
 
Specification
Operating temperature: 50℃ to 300℃
Operating pressure: -0.1 to 10 MPa
Burst pressure: 12.5 MPa
316L Stainless steel construction. Other materials such as Hastelloy, Zirconium, Titanium are available for customisation
Stir speed: 150 - 1500 rpm
 
Application
Digestion of insoluble substances
Sample dissolution pretreatment in atomic absorption spectroscopy and plasma emission analysis
Chemical synthesis reactions
Sample pretreatment for chemical analysis
Organic synthesis
Hydrothermal synthesis
Crystal growth
Sample extraction
 
General Instructions
The reactor should be used only by trained personnel 
Twist the screw-type threaded stainless steel (SS) cap in an anti-clockwise direction.
Remove the SS lid (one at the top of the PTFE chamber and the other is on the bottom of the PTFE chamber)
Take our the PTFE chamber and add the solvent into the PTFE liner (Note: Ensure that the total volume of the solvent is always less than 80% of the full capacity of the PTFE liner)
Make sure that the PTFE cap is air-tight to avoid pressure leakage
Place the PTFE liner and the SS lids in the original position
Twist the SS cap in a clockwise direction and use the metal rod to further tighten the cap to avoid pressure leakage
The autoclave reactor is now ready for heating in a oven